13 90 500 Replacing the tank vent valve (N14, N18)

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary work:

Installation location:

Unlock and disconnect line (1).

Unclip line (2) from holder (3). Unlock line (2) and detach from intake plenum.

Detach tank vent valve (4) from holder until the connector is accessible. Unlock and pull off the connector and remove the tank vent valve (4).

Fig 1: Removing Tank Vent Valve

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Read out fault memory of DME control unit.

Delete fault memory.