00 11 500 Checking/topping up oil level in automatic transmission (AISIN): Notes
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
Use only the approved automatic transmission oil. See OPERATING FLUIDS
.
Failure to comply with this requirement will result in serious damage to the automatic transmission!
Installation note:
Details of approved oil grade:
refer also to adhesive label on transmission oil sump.
NOTE:
Level out oil level in automatic transmission via overflow connector.
Necessary preliminary tasks:
Remove underbody protection.
Remove heat shield from hydraulic steering gear.
NOTE:
Only for vehicles with hydraulic steering gear.
Move selector lever to "P" position.
The vehicle must be horizontal and secured against rolling off.
Connect BMW diagnosis system.
Release oil filler plug with special tool 24 4 240.
Tightening torque: 25 Nm.
NOTE:
Graphic similar.