12 61 280 Removing and installing/replacing oil pressure sensor (N12)

WARNING: This page is about a different variant/trim than selected.

Special tools required:

WARNING: Scalding hazard!
Only perform this task on an engine that has cooled down.

Necessary preliminary tasks:

Installation location:

On cylinder head, left.

Engine oil may emerge when oil pressure sensor is replaced; have a cleaning cloth ready.

Release screw.

Pull intake muffler (1) towards top and detach clean air pipe (2).

Detach intake muffler (1) from air filter housing and remove.

Remove clean air pipe (2).

Fig 1: Removing Intake Muffler

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock and detach plugs (1 and 2).

Unlock and disconnect line (3).

Carefully pull cable duct (4) upwards slightly.

Fig 2: Removing Cable Duct

Courtesy of BMW OF NORTH AMERICA, INC.

Release oil pressure sensor (1) with special tool 11 7 020.

Installation:

Replace sealing ring.
Tightening torque 12 61 1AZ.
Check engine oil level, top up engine oil if necessary.

Fig 3: Releasing Oil Pressure Sensor With Special Tool 11 7 020
Courtesy of BMW OF NORTH AMERICA, INC.