11 36 Variable Camshaft Control
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATION - VARIABLE CAMSHAFT CONTROL
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ VANOS to inlet camshafts | N14 | M10x52 | Replace screw Jointing torque Torque angle |
20 Nm 180 ° |
| 2AZ Sprocket wheel to exhaust camshafts | N14 | M10x30 | Replace screw Jointing torque Torque angle |
20 Nm 90 ° |
| 3AZ Non-return valve VANOS to cylinder head | N14 | M14 x 1.5 | Replace sealing ring | 13 Nm |
| 4AZ Solenoid valve holder to crankcase | N14 | M6x16 | 9 Nm |