11 22 Flywheel
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATION - FLYWHEEL
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Flywheel to crankshaft (automatic transmission) | N14 | M9x1.25 | Replace screws 1. Jointing torque 2. Jointing torque 3. Final tightening |
8 Nm 30 Nm 90 ° |
| 2AZ DM flywheel to crankshaft (manual transmission) | N14 | M9x1.25 | Replace T55 screw 1. Jointing torque 2. Jointing torque 3. Final tightening |
8 Nm 30 Nm 90 ° |