11 12 Cylinder Head with Cover
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATION - CYLINDER HEAD WITH COVER
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Cylinder head bolts | N14 | M8x95 | Replace screws Jointing torque 1st angle of rotation 2. Angle of rotation |
15 Nm 90 ° 90 ° |
| 2AZ Cylinder head bolts | N14 | M10x145 | Replace screws Jointing torque 1st angle of rotation 2. Angle of rotation |
30 Nm 90 ° 90 ° |
| 3AZ Cylinder head bolts | N14 | M8x35 | Replace screws | 30 Nm |
| 4AZ Cylinder head cover to cylinder head | N14 | M6x30 | 10 Nm | |
| 5AZ Ground cable to cylinder head cover | N14 | M5 | 10 Nm | |
| 6AZ Inlet camshaft bearing cap to cylinder head | N14 | M6 | 10 Nm | |
| 7AZ Exhaust camshaft bearing cap to cylinder head | N14 | M6 | 10 Nm | |
| 8AZ Lifting lug to cylinder head | N14 | M8x20 M8x25 |
20 Nm | |
| 9AZ Acoustic cover to cylinder head cover | N14 | M6x40 | 8.5 Nm |