11 37 020 Removing and installing/replacing positioning motor for eccentric shaft (N12)

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Disconnect plug connection (2) on servodrive.

Pull off engine wiring harness at retaining clip (1) from servodrive.

Fig 1: Identifying Plug Connection And Retaining Clip

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque 11 37 4AZ

Installation:

Replace seal.

Fig 2: Identifying Screws

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Risk of damage to intermediate shaft.

Turn screwdriver (1) counterclockwise in direction of arrow and relieve tension on intermediate shaft.

NOTE: Do not rotate shaft too far up to maximum to end stop.

Remove servodrive.

Installation:

Insert servodrive with screwdriver (2).

Fig 3: Turn Screwdriver (1) Counterclockwise In Direction Of Arrow And Relieve Tension On Intermediate Shaft

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.

Check function of DME.