11 22 500 Removing and installing or replacing flywheel (N12)

WARNING: This page is about a different variant/trim than selected.

Special tools required:

Necessary preliminary tasks:

Lock flywheel with special tool 11 9 590.

Fig 1: Identifying Special Tool (11 9 590)

Courtesy of BMW OF NORTH AMERICA, INC.

Flywheel for automatic transmission.

Release flywheel bolts (1).

Tightening torque 11 22 1AZ

Installation:

Flywheel (1) is secured with an alignment pin.

Fit new flywheel screws.

Clean crankshaft thread for flywheel screws.

Fig 2: Identifying Flywheel Bolts (1 Of 2)

Courtesy of BMW OF NORTH AMERICA, INC.

Flywheel for manual gearbox.

Flywheel with and without dual-mass: release bolts (1).

Installation:

Flywheel is secured with a dowel pin.

Fit new flywheel screws.

Tightening torque 11 22 2AZ

Fig 3: Identifying Flywheel Bolts (2 Of 2)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Sensor gear (1) is loose on crankshaft and is first secured to flywheel.

Dowel pin (2) for securing sensor gear/flywheel.

Fig 4: Identifying Sensor Gear And Dowel Pin

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.