11 12 729 Checking cylinder head for water leaks (N12)

WARNING: This page is about a different variant/trim than selected.

Special tools required:

Necessary preliminary tasks:

Install special tool 11 9 521 with special tool 11 9 523.

Installation:

Install special tool 11 9 521 so that all water ducts are sealed.

Fig 1: Identifying Special Tool (11 9 521)

Courtesy of BMW OF NORTH AMERICA, INC.

Secure special tool 11 9 523 to 25 Nm.

Fig 2: Identifying Special Tool (11 9 523)

Courtesy of BMW OF NORTH AMERICA, INC.

Screw special tool 11 9 522 into place with existing screws (1 and 3) of coolant thermostat.

Sealing flange must rest flat.

NOTE: Compressed air at valve (2) must not exceed 3 bar.

Heat cylinder head to 60°.

Visually check for bubble formation in a water bath.

Fig 3: Identifying Screws And Valve

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.