34 35 001 Replacing a rear brake pad sensor
WARNING: This page is about a different variant/trim than selected.
Necessary preliminary tasks:
- Remove wheel.
- Remove rear right underbody panelling . See 51 47... REMOVING AND INSTALLING/REPLACING REAR LEFT OR RIGHT UNDERBODY PANELLING .
IMPORTANT:
The brake pad wear sensor must be replaced once it has been removed (brake pad wear sensor loses its retention capability in the brake pad).
If a brake pad sensor that has already been ground has to be replaced even though the minimum brake pad thickness has not yet been reached, you must observe the following: The new sliding contact must be filed down with a file to the same length as the ground sliding contact. See BRAKES - TECHNICAL DATA -- CLUBMAN .
If a brake pad sensor that has already been ground has to be replaced even though the minimum brake pad thickness has not yet been reached, you must observe the following: The new sliding contact must be filed down with a file to the same length as the ground sliding contact. See BRAKES - TECHNICAL DATA -- CLUBMAN .
Detach brake pad sensor (1) in direction of arrow from brake pad.
Unclip brake pad sensor (1) from holder (2).
Installation:
Make sure brake pad sensor (1) is correctly seated in brake pad.
Disconnect plug connection (1).
Unclip brake pad sensor from holder (2).
Installation:
Make sure plug connection engages correctly.