34 00 010 Checking thickness of brake lining

WARNING: This page is about a different variant/trim than selected.

Special tools required:

34 1 260 . See BRAKES - SPECIAL TOOLS -- CLUBMAN .

NOTE: The thickness of the outer brake pads can be determined without removing the road wheels.
If necessary, move car until inspection opening for brake pad wear indicator (brake pad) can be seen through rim.

Insert special tool 34 1 260 through rim into recess for brake pad wear indicator.

Fit special tool on brake pad, slide ring (1) in direction of arrow towards well and read off measured value.

In this case, a brake pad thickness of 6 mm is measured.

Fig 1: Identifying Special Tool On Brake Pad And Slide Ring

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE:

Brake disk
Brake lining
Safe limit for lining wear on front brake. See BRAKES - TECHNICAL DATA -- CLUBMAN .

Safe limit for lining wear on rear brake. See BRAKES - TECHNICAL DATA -- CLUBMAN .