34 35 001 Replacing a front brake pad sensor
WARNING: This page is about a different variant/trim than selected.
Necessary preliminary tasks:
- Remove wheel .
IMPORTANT:
The brake pad wear sensor must be replaced once it has been removed (brake pad wear sensor loses its retention capability in the brake pad).
If a brake pad sensor that has already been ground has to be replaced even though the minimum brake pad thickness has not yet been reached, you must observe the following: The new sliding contact must be filed down with a file to the same length as the ground sliding contact. See BRAKES - TECHNICAL DATA -- CLUBMAN .
If a brake pad sensor that has already been ground has to be replaced even though the minimum brake pad thickness has not yet been reached, you must observe the following: The new sliding contact must be filed down with a file to the same length as the ground sliding contact. See BRAKES - TECHNICAL DATA -- CLUBMAN .
Press clip (1) together and detach brake pad sensor (2) in direction of arrow from brake pad.
Unclip brake pad sensor (2) from holder (3).
Installation:
Make sure clip (1) and brake pad sensor (2) are correctly seated in brake pad.
Disconnect plug connection (1).
Installation:
Make sure plug connection engages correctly.