64 11 Heater and Controls
WARNING: This page is about a different variant/trim than selected.
HEATER AND CONTROLS TIGHTENING TORQUES SPECIFICATION
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Nut, guide pin, heater | R50, R52, R53 | M6 | 7.5 Nm | |
| 2AZ Heater to instrument panel trim, bottom | R50, R52, R53 | 3 Nm | ||
| 3AZ Heater to cross-member | R50, R52, R53 | 4 Nm | ||
| 4AZ Line / A/C system to expansion valve | R50 / R52 / R53 | M6 x 20 | 7.5 Nm | |
| R55, R56 | 8 Nm | |||
| 5AZ Clamping screws to expansion valve | R50, R52, R53, R55, R56 | 5.5 Nm |