51 11 Front Bumper
WARNING: This page is about a different variant/trim than selected.
FRONT BUMPER BOLTS SPECIFICATION
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Spoiler, bumper, lower, to front panel | R50, R52, R53 | M6 | 6 Nm | |
| 2AZ Bumper to front panel | R50, R52, R53 | M6 | 6 Nm | |
| 3AZ Carrier to body | R50, R52, R53, R55, R56 | M8 | Nut | 22 Nm |
| 4AZ Carrier to bracket, bumper, front | R50, R52, R53 | M8 x 30 | Screw | 22 Nm |
| R55, R56 | M8 | 18.5 Nm | ||
| 5AZ Adjusting fixture to front panel | R50, R52, R53 | M6 x 20 | 6 Nm | |
| 6AZ Adjusting device to bumper | R50, R52, R53 | M6 x 20 | 6 Nm | |
| 7AZ Lock bridge to body | R55, R56 | 22 Nm |