65 50 011 Removing and installing (replacing) video module for on-board monitor

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection). See 61 35... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .

Necessary preliminary tasks:

NOTE: Comply with notes and instructions on handling optical waveguides. See 61 00... NOTES ON HANDLING OPTICAL FIBERS .

Release screws (1) and remove cover (2) in direction of arrow.

Fig 1: Retaining Screws, Cover And Removal Direction

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Unfasten screws (2).

Unlock retaining lug (3) and remove video module (4).

Fig 2: Plug Connection, Mounting Screws, Retaining Lug And Video Module

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement: