65 20 022 Removing and installing/replacing roof-mounted aerial/antenna

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection). See 61 35... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .

Necessary preliminary tasks:

Disconnect plug connection (1).

Fig 1: Identifying Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Release retainer (2) and feed out roof antenna with leads towards top.

Tightening torque 65 20 1AZ.

Fig 2: Identifying Plug Connection And Retainer

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Roof antenna shown removed for purposes of clarity.

Installation:

Ensure correct cable routing.

Feed antenna leads (1) through groove (2).

Tab (3) when installed secures antenna leads.

Fig 3: Identifying Antenna Leads, Groove And Tab

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure guide (1) is correctly seated in roof opening (2).

Seal (3) must not be damaged.

Align roof antenna to car longitudinal axis.

Fig 4: Identifying Guide, Roof Opening And Seal

Courtesy of BMW OF NORTH AMERICA, INC.