64 11 221 Replacing resistor for heating and air conditioning unit blower (IHR/IHKR)

WARNING: This page is about a different variant/trim than selected.

Release screws (1) and feed out cover (2) towards bottom.

Fig 1: Releasing Screws (1) And Feeding Out Cover (2) Toward Bottom

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock retaining lug (1). Pull the resistor (2) in direction of arrow out of the guide.

Fig 2: Pulling Resistor In Direction Of Arrow Out Of Guide

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten plug connection (1) and disconnect. Take off resistor (2).

Fig 3: Removing Resistor

Courtesy of BMW OF NORTH AMERICA, INC.