63 10... Adjust The Low-Beam Headlight (With Electronic Headlight Adjustment Device Maha Lite 3)

WARNING: This page is about a different variant/trim than selected.

Comply with TEST PREREQUISITES FOR HEADLIGHT ADJUSTMENT .

Refer to the manufacturer's operating instructions for the headlight adjustment device!

Switch on the headlight adjustment device by pressing any button.

Press F1 button. The shown display screen appears.

Perform the following settings:

Passenger car must be selected
Enter the setting dimension of the headlight via the buttons F1/F2: - 1, 0 % to - 1, 1 % (see "light/dark boundary of the headlight in the headlight adjustment device" in TEST PREREQUISITES FOR HEADLIGHT ADJUSTMENT ).

Fig 1: Display - Headlight Adjustment Device Screen
Courtesy of BMW OF NORTH AMERICA, INC.
The right / left-hand traffic must be selected according to the country.
Select the headlight type via the button F3:
- EC: for halogen and xenon headlights
- EC LED: for LED headlight

The adjusted values are adopted for future measurements.

Fig 2: Display - Headlight Adjustment Values

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Before measuring/adjusting the low-beam headlight, it is absolutely necessary to determine the TRANSPARENT SCREEN OF THE HEADLIGHT !
An incorrect selection leads to an incorrect setting!

Transparent screen Type I :

Briefly press the button for the applicable side of the vehicle (3) until symbol (4) appears.

Transparent screen Type II :

Press the button for the applicable side of the vehicle (3) for 3 seconds . The measured values will appear on the display. Symbol (4) will be displayed.

The following symbols appear in the display:

OK (2): Adjustment is optimal.
OK (5): Adjustment is within the legal tolerance range. ADJUST THE HEADLIGHT until O. K. (2) is displayed.
Arrows (6): Adjustment is incorrect. Use the arrows (6) to ADJUST THE HEADLIGHT until O. K. (2) is displayed.