61 61 010 Checking/adjusting contact angle of windscreen wiper arms on windscreen
WARNING: This page is about a different variant/trim than selected.
Special tools required:
- 00 9 220 . See MAINTENANCE AND GENERAL INFORMATION - SPECIAL TOOLS -- S CLUBMAN .
- 61 6 100 . See GENERAL ELECTRICAL SYSTEM - SPECIAL TOOLS -- S CLUBMAN .
NOTE:
The wipe quality is improved by precise adjustment of the contact/approach angle of the wiper arms.
Necessary preliminary tasks:
- Remove wiper blade .
Insert windscreen wiper arm (1) in special tool 61 6 100.
Using screw (2) and pressure plate (3), locate windscreen wiper arm (1) and position on windscreen.
Read off value in degrees, adjust wiper arm if necessary.
NOTE:
Windscreen wiper arm (1) must rest correctly on lower and side contact surfaces (4) of special tool 61 6 100.
On right-hand-drive cars, screw (2) must be located on left side of special tool 61 6 100.
On right-hand-drive cars, screw (2) must be located on left side of special tool 61 6 100.
Press special tools 00 9 220 in appropriate direction until contact/approach angle is obtained.