61 71 015 Removing and installing/replacing a spray nozzle in windscreen washer system

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Remove insulation lining on engine hood/bonnet in area of spray nozzle

Pull off hose (1).

If necessary, disconnect plug connection (2).

Press out spray nozzle of windscreen washer system in direction of arrow.

Installation:

Check contact points of jet sprays.

If necessary, adjust spray nozzle.

Fig 1: Removing Spray Nozzle In Windscreen Washer System

Courtesy of BMW OF NORTH AMERICA, INC.