61 14 030 Removing and installing/replacing B+ multifuse distributor

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

NOTE: Battery shown removed for purposes of clarity.

Pull B+ distributor (1) in direction of arrow out of bracket (2).

Installation:

Make sure B+ distributor (1) is correctly engaged on bracket (2).

Fig 1: Pulling B+ Distributor Out Of Bracket

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock catches (1) with a suitable tool and remove B+ distributor cover (2) towards rear from B+ distributor (3).

Installation:

Make sure B+ distributor cover (2) is correctly seated on B+ distributor (3).

Fig 2: Identifying Catches, B+ Distributor And Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew nut (1). Tightening torque 61 14 1AZ .

Disconnect plug connections (2) and remove B+ distributor (3).

Installation:

Plugs are color- and mechanically coded.

Ensure correct contacting.

B+ distributor can only be replaced as a complete unit (with fuses).

Fig 3: Identifying Plug Connections, Nut And B+ Distributor

Courtesy of BMW OF NORTH AMERICA, INC.