54 13 053 Replacing all gaskets on rear glass slide/tilt sunroof cover
WARNING: This page is about a different variant/trim than selected.
Necessary preliminary tasks:
NOTE:
Follow REPAIR INSTRUCTIONS for bonded seals on panorama sunroof
Pull seals off glass slide/tilt sunroof cover.
Installation note:
- Clean bonding surface with adhesive remover
- Press seal without stretching (squashing).
- Stick on seal in sections
IMPORTANT:
Do not touch bonding surface.
Surface temperature ≥ 20 °C
Incorrect bonding of the seal will result in leakage.
Surface temperature ≥ 20 °C
Incorrect bonding of the seal will result in leakage.