52 26 303 Removing and installing/replacing actuator for rear seat backrest

Necessary preliminary tasks: 

• Remove BACKREST COVER 

Unclip trim (1) and feed out from release lever (2).

Installation: 

Retaining lugs must not be damaged.

If necessary, replace faulty trim (1).

Fig 1: Unclip Trim (1) And Feed Out From Release Lever (2)

Courtesy of BMW OF NORTH AMERICA, INC.

Feed Bowden cable (2) out of grip recess plate (1).

Fig 2: Feed Bowden Cable (2) Out Of Grip Recess Plate (1)

Courtesy of BMW OF NORTH AMERICA, INC.

Press in detent lugs and remove grip recess plate (1).

Fig 3: Locating Recess Plate (1)

Courtesy of BMW OF NORTH AMERICA, INC.