52 13 198 Removing and installing/replacing rear panel on left or right front seat backrest (normal/manual)

WARNING: This page is about a different variant/trim than selected.

Raise release handle and release screw (1).

Tightening torque 52 13 5AZ

Detach release handle.

Release screws (2).

Tightening torque 52 13 7AZ

Fig 1: Raising Release Handle And Release Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Retaining hook in marked area must be levered out from backrest frame without incurring damage.

Reach between rear panel and backrest cover.

Pull rear panel upwards and at same time lever out of backrest frame.

Fig 2: Pulling Rear Panel Upwards

Courtesy of BMW OF NORTH AMERICA, INC.