51 13... Decal stripes on engine hood/bonnet
WARNING: This page is about a different variant/trim than selected.
NOTE:
Notes and information
on sticking film/foil are an essential part of these instructions and must be followed without fail.
Stick on decal stripes using the wet bonding procedure.
Stick on decal stripes using the wet bonding procedure.
Decal stripe position:
Mark centerline (1) of hood/bonnet at rear between spray nozzles and at front below MINI emblem.
Mark dimensions (A and B) on hood/bonnet.
COOPER/ONE:
A = 300 mm
B = 210 mm
COOPER S:
A = 380 mm
B = 250 mm
Stick on decal stripes.