51 13 102 Removing and installing/replacing trim on front left or right wheel arch

WARNING: This page is about a different variant/trim than selected.

If necessary, release clip on wheel arch trim (1).

Bend wheel arch trim (1) inwards slightly and release clip (2).

Installation:

If necessary, replace faulty clip (2).

Fig 1: Identifying Clip And Arch Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Feed trim (1) in area (A) towards front out of bumper.

Release trim (1) from clips (2); if necessary, disconnect associated plug connection and remove.

Installation:

If necessary, replace faulty clips (2).

Fig 2: Releasing Trim From Clips

Courtesy of BMW OF NORTH AMERICA, INC.

If replacing with USA national version:

Remove side marker lamp. See CLEARANCE AND SIDE MARKER .