51 71 426 Removing and installing/replacing panel for cover on left or right side member

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Release clips (1).

Installation:

If necessary, replace faulty clips (1).

Fig 1: Identifying Clips

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1) and screw rivets (2).

Fig 2: Identifying Screw And Screw Rivets

Courtesy of BMW OF NORTH AMERICA, INC.

R55 right side only:

Lever out trim (1) with a suitable tool.

Release clips (2).

Installation:

If necessary, replace faulty clips (2).

Fig 3: Identifying Clips

Courtesy of BMW OF NORTH AMERICA, INC.

Release panel (1) at clips (2) and remove.

Fig 4: Releasing Panel (1) At Clips (2)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, replace faulty clips (1 and 2).

Fig 5: Identifying Clips

Courtesy of BMW OF NORTH AMERICA, INC.