51 31... General procedure when dismantling/installing bonded window glass: Dismantling
WARNING: This page is about a different variant/trim than selected.
The following dismantling methods are applied, according to the version:
- ROLL OUT 2000
- OSCILLATING KNIFE
- Cutting wire with WIRE PULL HANDLES
NOTE:
When cutting out the window glass with wire pull handles, there is a risk of damage to the window glass if the wire is pulled over the window edge.
Unless otherwise described, only use this method when replacing the window glass.
Unless otherwise described, only use this method when replacing the window glass.
Follow the vehicle-specific repair instructions!