51 47 314 Removing and installing/replacing carpet for passenger compartment
WARNING: This page is about a different variant/trim than selected.
Necessary preliminary tasks:
- Remove both front seats . See SEATS - REPAIR INSTRUCTIONS -- S CLUBMAN .
- Remove airbag control unit . See 65 77 016 REMOVING AND INSTALLING AIRBAG CONTROL UNIT .
- Remove rear storage compartment holder .
- Remove both inner entrance cover strips .
- Remove rear seat . See SEATS - REPAIR INSTRUCTIONS -- S CLUBMAN .
- Remove lower trim from instrument panel .
- Remove accelerator pedal module . See 35 40 001 REMOVING AND INSTALLING/REPLACING ACCELERATOR PEDAL MODULE .
- Detach side trim panels at bottom.
R55 only:
- Remove cover on left entrance .
R55 with shelf package only:
Remove lashing eyes on left/right:
- Release screw (1).
- Tightening torque 51 71 9AZ .
- Remove cover (2)
- Turn lashing eye (3) through 90° and feed out
Version with TV/telephone:
Release screws (1) and remove cover (2).
Release screws (1) and remove cover (2).
Release trim (1) from retainers (2) and remove towards inside.
Release screw (1) and remove trim (2).
Release screws (1 and 2).
Take off holder (3).
Remove carpet (1) first at rear towards top.
Pull back carpet (1) at front under heater (2).
NOTE:
A cut (3) is already provided in carpet (1).
Pay attention to cable when removing carpet (1).
If necessary, cut carpet (1) to feed out cable.
Pay attention to cable when removing carpet (1).
If necessary, cut carpet (1) to feed out cable.
Installation:
Make sure openings for air duct and attachment points are correctly positioned.