37 14 512 Replacing rear ride-height sensor

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Observe SAFETY INSTRUCTIONS for raising the vehicle

NOTE: Ride-height sensor holder on rear axle carrier, tightening torque 37 14 3AZ .
Jointed rod to holder, tightening torque 37 14 4AZ
Holder to upper control arm, tightening torque 37 14 5AZ .

IMPORTANT: Read and comply with NOTES ON PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Necessary preliminary tasks:

Partially detach underbody panelling

Disconnect plug connection (1).

Release nut (2) and remove jointed rod from sensor lever (3).

Installation:

Replace self-locking nut.

Sensor lever (3) must point from ride-height sensor to lower control arm.

Tightening torque 37 14 4AZ

Fig 1: Identifying Plug Connection, Nut And Sensor Lever

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) and remove ride-height sensor.

Installation:

Tightening torque 37 14 1AZ

Fig 2: Identifying Screws

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

Check HEADLIGHT ADJUSTMENT , correct if necessary.