37 14 511 Replacing front ride-height sensor

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Observe SAFETY INSTRUCTIONS for raising the vehicle

NOTE: Jointed rod to holder, tightening torque 37 14 4AZ .
Holder to control arm, tightening torque 37 14 5AZ

Release screw (1).

Remove holder for ride-height sensor from front axle carrier and disconnect plug connection (3).

Installation:

Sensor lever (2) must point from ride-height sensor to left front wheel.

Tightening torque 37 14 2AZ

Release nut (4) and remove jointed rod from sensor lever (2).

Fig 1: Identifying Plug Connection, Bolt And Sensor Lever

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Replace self-locking nut.

Tightening torque 37 14 4AZ

Installation:

Align ride-height sensor holder by means of lug (1) to opening (2) in front axle carrier.

Fig 2: Identifying Sensor Holder And Opening

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) and remove ride-height sensor (2).

Tightening torque 37 14 1AZ

Fig 3: Identifying Screws And Ride-Height Sensor

Courtesy of BMW OF NORTH AMERICA, INC.

After installation: