41 11 720 Replacing rear left side member (partial replacement, rear panel and side panel at rear left removed)

WARNING: This page is about a different variant/trim than selected.

Refer to relevant service information in BODY, GENERAL .

Use only approved SPOT-WELDING APPARATUS for repairs.

Remove or cover those vehicle components in the repair area which are susceptible to heat or dust.

Place vehicle on straightening bench.

The following new body parts are required:

Fig 1: Identifying Rear Axle Carrier Lower Section And Rear Wheel Arch

Courtesy of BMW OF NORTH AMERICA, INC.

Mark severance cut in accordance with dimension and cut.

Distance a = approx. 150 mm from cross-member, luggage compartment floor.

Cut through frame side member completely.

Open weld joints in areas (1).

Fig 2: Identifying Open Weld Joints Areas

Courtesy of BMW OF NORTH AMERICA, INC.

Open weld joints in areas (1).

Fig 3: Identifying Open Weld Joints Areas

Courtesy of BMW OF NORTH AMERICA, INC.

Open weld joints in area (1).

Remove frame side member.

Fig 4: Identifying Open Weld Joints Areas

Courtesy of BMW OF NORTH AMERICA, INC.

Preparation of new part:

Mark severance cut (1) in accordance with body and cut.

Open weld joints in area (2).

Fig 5: Identifying Open Weld Joints Areas

Courtesy of BMW OF NORTH AMERICA, INC.

Preparation of new part:

Mark severance cut (1) in accordance with body and cut.

Installation:

Weld in REINFORCING PANELS at all severance cuts.

Fig 6: Mark Severance Cut In Accordance With Body And Cut

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Adjust new parts (1 and 2) to fit in accordance with body and secure.

Weld new parts (1 and 2) to begin with and install as a composite unit.

Fig 7: Weld New Parts (1 And 2) To Begin With And Install As A Composite Unit

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Adjust new part to fit with straightening attachment or universal mount.