41 11 151 Replacing cover for right frame side member

WARNING: This page is about a different variant/trim than selected.

Refer to relevant service information in BODY, GENERAL .

Remove or cover those vehicle components in the repair area which are susceptible to heat or dust.

Use only approved SPOT-WELDING APPARATUS for repairs.

The following new body parts are required:

Fig 1: Identifying Side Frame, Outer

Courtesy of BMW OF NORTH AMERICA, INC.

Mark severance cuts in accordance with illustration and cut.

CAUTION: Cut outer plate only for following severance cuts.

Measurement b = approx. 120 mm after elongated hole dia.

12x18 mm.

Measurement a = approx. 130 mm before hole dia. 10x12 mm.

Open weld joints in areas (1).

Fig 2: Identifying Open Weld Joints Areas

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Mark new part in accordance with severance cuts above and cut.

Weld in REINFORCING PANELS at all severance cuts.