41 51 080 Removing and installing door

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Do not damage adjoining body parts.

Open door.

Release screw on connector frame.

Front door:

Tightening torque 41 51 3AZ

Fig 1: Locating Screw On Connector Frame

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Secure door against closing.

Release screw on door retainer.

Tightening torque 51 21 6AZ

IMPORTANT: Secure door against falling out.

Release screws (1) and pull out of hinges.

Tightening torque 41 51 1AZ

Fig 2: Releasing Screws And Pull Out Of Hinges

Courtesy of BMW OF NORTH AMERICA, INC.

Pull plug connection from door pillar, unlock by pulling out bar and detach.

Unhinge door by moving upwards and placing it on a suitable surface.

Installation:

If necessary, ADJUST DOOR .

Fig 3: Pulling Plug Connection From Door Pillar

Courtesy of BMW OF NORTH AMERICA, INC.