41 61 000 Removing and installing engine compartment lid

WARNING: This page is about a different variant/trim than selected.

Refer to relevant service information in BODY, GENERAL .

Necessary preliminary tasks:

Slacken screws (1)

Unfasten screws (2).

Tightening torque 41 61 1AZ

Remove engine hood/bonnet with assistance of a second person.

Installation:

Install engine hood at screw locations to on hinge. This dispenses with the need for adjustment after installation.

Fig 1: Slacken Screws And Unfasten Screws

Courtesy of BMW OF NORTH AMERICA, INC.

If this is not possible, adjust engine hood.