41 00... Straightening steel parts

1.0 Recommended tools 

Only use those tools designed for steel repairs.

2.0 Straightening outer shell 

• "Cold" straightening: Press dents out from their center and smooth in an inwards direction with gentle taps.

  In the case of small, soft dents (hail and parking damage), this is also possible without damaging the paintwork. This work requires a special tool and a trained worker.

• "Hot" straightening: Heat dents in their central point only with a gas flame until bright red hot. Then quench the material with a wet cloth.
• Stud welding can be used in the case of damage where access is only possible from one side.
• Avoid cracking.
• Avoid hardening and overstretching.
• Avoid heating and overheating the outer shell over large areas.
• If, after steel parts have been straightened, the surface shows no dents larger than 2 mm, these dents may be touched up with knifing filler.

  Dents larger than 2 mm must be treated with filling solder.

  NOTE: Only applicable within the European Union!

  European used-car regulations prohibit the use of tin containing lead in motor vehicles introduced after 01.07.2003!

• For safety vehicles, follow the special notes and information in the repair instructions.

3.0 Straightening structure 

• Repairs affecting the mounting points of assemblies and chassis/suspension components must be carried out on the straightening bench with the matching straightening attachment set or specification sheet for the vehicle.

  Straightening attachments and specification sheets are also available for the top section, e.g.: door pillars, convertible top mounts, cowl, rear lid hinges, etc.

• Check windshield and rear window apertures for curvature by inserting the original glass.
• Take the gap dimensions for doors, engine hood and rear lid from the vehicle-specific gap dimension diagram.
• Bearing body components such as e.g. engine supports, door pillars, frame side members etc. with deformations which can no longer be returned to their original shape by "cold straightening" must be replaced.

  Heating bearing body components for better reshaping is not permitted! 

  Failure to comply with this requirement would result in a loss of original strength of up to 40 %.

• High-strength and super-high-strength steel plates as a rule cannot be reshaped. Reshaping only serves as a preparatory measure to replacing the component in order to achieve optimal joining of the connection points.
• The body must be anchored as follows for reshaping: 

  If using vehicle-specific/universal straightening attachment sets (Carbench/ Celette), it is necessary to secure the body additionally  with 4 retaining clips to the spot flange of entrance or to the 4 jacking points. The spot flange (if available) is to be preferred.

  If using universal electronic or mechanical straightening systems (Car-O-liner/ Celette), it is necessary to secure the body with 4 retaining clips to the spot flange of entrance or to the 4 jacking points. The spot flange (if available) is to be preferred. In addition  anchor at least 2 points with the securing set.

  Failure to comply with these instructions will result in damage to the body during reshaping in non-damaged areas. Vehicle specific straightening attachments and universal mounts may be damaged.