41 00... Notes on repairing threads
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
Install Helicoil thread inserts so that they are flush with the original thread.
NOTE:
Damaged threads may be repaired with Helicoil thread inserts. Comply with the procedure described in the example.
THREADS SPECIFICATION CHART
| Screw/bolt connection | Vehicle | Screw/bolt fastening point(s) | Helicoil thread insert |
|---|---|---|---|
| Front axle carrier to engine support | R50, R52, R53 | All | M12x1.5x18 |
| R55, R56 | All | M12x1.5x18 | |
| Bracket, control arm, to engine support | R50, R52, R53 | All | M10x15 |
| R55, R56 | All | M10x15 | |
| Bracket, control arm, to front axle carrier | R55, R56 | All | M14x1.5x21 |
| Rear axle carrier to frame side member / crossmember | R50, R52, R53 | All | M12x1.5x18 |
| R55, R56 | All | M12x1.5x18 | |
| Bearing block, trailing arm to frame side member | R50, R52, R53 | All | M12x1.5x18 |
| R55, R56 | All | M12x1.5x18 |