36 12 084 Replacing sealant bottle of M-Mobility system

WARNING: This page is about a different variant/trim than selected.

NOTE: This work step describes how the sealant bottle is replaced within the framework of inspection (M-Mobility system not used).
If the M-Mobility system has been used, also replace the transparent tire inflation hose.

Remove seal film (1). Not necessary if M-Mobility system has already been used.

Installation:

Replace seal film.

Fig 1: Identifying Seal Film

G04748061

Courtesy of BMW OF NORTH AMERICA, INC.

Release Torx threaded bolts (1) and raise cover as far as possible.

Installation:

Tightening torque 36 12 1AZ .

Fig 2: Identifying Torx Threaded Bolts

G04748062

Courtesy of BMW OF NORTH AMERICA, INC.

Release hexagon nut (1), grip nut firmly from underside.

Installation:

Tightening torque 36 12 2AZ .

Fig 3: Identifying Hexagon Nut

G04748063

Courtesy of BMW OF NORTH AMERICA, INC.

Lift sealant bottle out.

Fig 4: Identifying Sealant Bottle

G04748064

Courtesy of BMW OF NORTH AMERICA, INC.

Ensure that hose is laid without any kinks.

Fig 5: Identifying Hoses

G04748065

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Note the expiration date when installing a new sealant bottle.

Fig 6: Identifying Expiration Date Of Sealant Bottle

G04748066

Courtesy of BMW OF NORTH AMERICA, INC.