00 00... Front and rear brake linings: checking lining thickness with measuring gauge. If linings are replaced: cleaning brake shafts, checking brake disk thickness and surface, applying grease to wheel centering on alloy wheels. If rear linings are replaced: checking parking brake linings: Notes
WARNING: This page is about a different car, the 2005 BMW 745i, 2004 BMW 745i, 2003 BMW 745i, and 2002 BMW 745i. However, it is still accessible from the selected car via links, so may be relevant.
Check brake lining thicknesses with measuring gauge at front and rear.
NOTE:
Issue a separate invoice for replacing the brake linings.
Remove front and (if necessary) rear disk brake linings. See BRAKE LININGS (REAR)
NOTE:
- Clean brake shafts.
- Replace brake linings if they drop below minimum thickness (refer to Technical Data).
- Replace brake disks if they drop below minimum thickness (refer to Technical Data) and in event of scoring, heat cracks, lateral runout or thickness difference.
- Apply a thin coat of grease to wheel centering on light alloy wheels, refer to Service Information Operating Fluids.