12 63 520 Replacing master relay (M51, M52, M62): Notes

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2003 BMW 540i, 2002 BMW 540i, 2001 BMW 540i, 2000 BMW 540i, and 1999 BMW 540i. However, it is still accessible from the selected car via links, so may be relevant.

Switch off ignition.

Fold open locking bracket (1).

Remove rubber gasket (2).

Fig 1: Removing Rubber Gasket

Courtesy of BMW OF NORTH AMERICA, INC.

Remove retaining clip (3).

Pull filter housing (4) upwards to remove.

Fig 2: Removing Retaining Clip From Filter Housing

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew bolts (1).

Tightening torque, see 12 90 4AZ in ENGINE ELECTRICAL SYSTEM - TIGHTENING TORQUE .

Fig 3: Identifying Filter Housing Bolts

Courtesy of BMW OF NORTH AMERICA, INC.

M52, M62:

Master relay in Digital Motor Electronics
Engine fuses for Digital Motor Electronics

Fig 4: Identifying Master Relay In Digital Motor Electronics

Courtesy of BMW OF NORTH AMERICA, INC.

Notes on troubleshooting:

If the starter cranks the engine during the starting sequence but the engine fails to fire, check the engine fuses and, if necessary, replace them entirely along with the fuse holder.
Search for cause of melting of fuses.

M51:

Remove master relay (1) from Digital Diesel Electronics.