12 13 513 Replacing ignition coil

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 MINI Cooper, 2007 MINI Cooper, 2006 MINI Cooper, 2005 MINI Cooper, and 2004 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Switch off ignition
Read out fault memory of DME control unit
Check stored fault messages

Unlock plug (1) and remove.

Fig 1: Unlocking Plug

Courtesy of BMW OF NORTH AMERICA, INC.

Detach ignition cable (2) from ignition coil.

Release screws (3).

Installation:

Screw (1) and spacer tube (2) are only available as a single set.

Fig 2: Identifying Screw And Spacer Tube

Courtesy of BMW OF NORTH AMERICA, INC.

Check insulating rings (3), replace if necessary.

Tightening torque 12 13 1AZ. Refer to ENGINE ELECTRICAL SYSTEM - TIGHTENING TORQUES .

NOTE: Now clear the fault memory.