12 14 650 Replacing temperature and manifold absolute pressure sensor (COOPER S)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 MINI Cooper, 2007 MINI Cooper, 2006 MINI Cooper, 2005 MINI Cooper, and 2004 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Read out fault memory of EMS/DME control module, check stored fault memory, rectify faults, clear fault memory.

Turn off ignition.

Disconnect connector from TMAP sensor (1).

Fig 1: Removing Sensor

Courtesy of BMW OF NORTH AMERICA, INC.

Remove screws (2) and remove sensor (3). Replace O -rings (4).

Tightening torque 13 62 3AZ. Refer to FUEL SUPPLY SYSTEM - TIGHTENING TORQUES .

NOTE: Read out fault memory of EMS/DME control module, check stored fault memory, rectify faults, clear fault memory.