36 11 533 Removing and installing/replacing RDC wheel electronics: Notes

WARNING: This page is about a different car, the 2003 BMW 530i, 2002 BMW 530i, and 2001 BMW 530i. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: If a tire sealing fluid has been used, replace the wheel electronics.

When a tire has been removed, do not clean the rim with installed wheel electronics with high-pressure cleaning equipment.

Do not treat wheel electronics with solvents, cleaning agents etc. If dirty, wipe with a clean cloth only.

Do not clean wheel electronics with compressed air.

IMPORTANT: If the wheel electronics have been removed, the complete valve must be replaced.

Necessary Preliminary Tasks

Remove tires,

refer to 36 12 001 CHANGING A TYRE (ON FRONT, REAR OR SPARE WHEEL) .

Follow instructions on initializing Run Flat Indicator.