Removal & Installation of Quick-Release Coupling with Indication Pins
WARNING: This page does not describe the selected car, but rather 61 other vehicles, including the 2002 BMW Z3, 2002 BMW M Roadster, 2002 BMW M Coupe, 2001 BMW Z3, and 2001 BMW M Roadster. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Coupling is not correctly engaged if both indication pins (4) fail to protrude from housing. Leakage will occur. See Fig 1.
- Press plastic ring (2) into quick-release coupling (1) and remove coupling (1). See Fig 1.
- To install, push quick-release coupling (1) onto connector (3) until both indication pins (4) can be seen and felt to point outwards at outside diameter of housing. To check that quick-release coupling (1) has been correctly fitted, feel indication pins (4) at outside diameter of housing. When correctly seated, indication pins (4) cannot be pressed into housing.