11 12 Cylinder head and cylinder head cover

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 MINI Cooper, 2007 MINI Cooper, 2006 MINI Cooper, 2005 MINI Cooper, and 2004 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

CYLINDER HEAD AND CYLINDER HEAD COVER - TIGHTENING TORQUES - COOPER (1.6L) R50/W10 (1AZ - 13AZ)

	Type	Thread	Tightening specification	Measure
1AZ Cylinder head cover to cylinder head	W10/W11			12 N.m.
2AZ Thermostat to cylinder head	W10/W11 M6			12 N.m.
3AZ Cylinder head bolts to crankcase	W10/W11		Jointing torque	40 N.m.
			Torque angle	90 °
4AZ Cylinder head bolts to crankcase	W10/W11 M8			28 N.m.
5AZ Camshaft gear to camshaft	W10/W11 M12			102 N.m.
6AZ Seal plug, chain tensioner	W10/W11			63 N.m.
7AZ Seal plug to cylinder head	W10/W11			18 N.m.
8AZ Intake manifold to cylinder head	W10/W11 M8			26 N.m.
9AZ Engine carrier to cylinder block	W10/W11			100 N.m.
10AZ Hydro-mount to body (screw)	W10/W11	M10 x 110	Jointing torque	56 N.m.
			Torque angle	90 °
11AZ Hydraulic-mount to body	W10/W11			100 N.m.
12AZ Guide and tensioning rail to cylinder head	W10/W11	M8		28 N.m.
13AZ Engine mounting to engine mount	W10/W11			68 N.m.

CYLINDER HEAD AND CYLINDER HEAD COVER - TIGHTENING TORQUES - COOPER (1.6L) R50/W10 (14AZ - 21AZ)

	Type	Thread	Tightening specification	Measure
14AZ Upper stabilizer bracket to body mounting	W10/W11			100 N.m.
15AZ Upper stabilizer bracket to engine mounting	W10/W11			100 N.m.
16AZ Lower stabilizer to oil sump holder	W10/W11			100 N.m.
17AZ Lower stabilizer to front axle	W10/W11			100 N.m.
18AZ Engine vent valve to cylinder head cover	W10/W11			7 N.m.
19AZ Stabilizer bracket to oil sump	W10/W11			45 N.m.
20AZ Mounting screws for mounting (left) of intercooler to intake manifold	W11 M6			9 N.m.
21AZ Mounting screws for mounting (right) of intercooler to intake manifold	W11 M6			9 N.m.