61 62 030 Replacing (removing and installing) wiper arm for rear window wiper (up to 07/2004)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 MINI Cooper, 2007 MINI Cooper, 2006 MINI Cooper, 2005 MINI Cooper, and 2004 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

For Special Tool identification, see GENERAL ELECTRICAL SYSTEM - SPECIAL TOOLS - COOPER (1.6L) R50/W10 .

Special Tools Required:

61 6 210

Open protective cap with integrated spray nozzle (1) to expose nut.

Release nut on wiper arm.

Tightening torque, refer to 61 62 1AZ in GENERAL ELECTRICAL SYSTEM - TIGHTENING TORQUE - COOPER (1.6L) R50/W10 .

Press off wiper arm (2) with special tool 61 6 210.

Fig 1: Removing Wiper Arm With Special Tool

G03307069

Courtesy of BMW OF NORTH AMERICA, INC.

Engagement tongues (1) and inlet of spray nozzle (2) in protective cap (3) must not be damaged.

Fig 2: Identifying Spray Nozzle

G03307070

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Rear window wiper must be in rest position.

Adjust distance (1) between wiper arm and rear window edge.

44 mm.

Replacement:

Remove and install rear window wiper blade. Refer to 61 62 020 REMOVING AND INSTALLING/REPLACING REAR WIPER BLADE .

Fig 3: Removing/Installing Rear Window Wiper Blade

G03307071

Courtesy of BMW OF NORTH AMERICA, INC.