51 16 216 Removing and installing rear storage compartment (with center armrest)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 MINI Cooper, 2007 MINI Cooper, 2006 MINI Cooper, 2005 MINI Cooper, and 2004 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

For Special Tool identification, see MAINTENANCE AND GENERAL INFORMATION - SPECIAL - COOPER (1.6L) R50/W10 .

Special Tools Required:

00 9 317

Release screws (1) on left/right.

Remove cover (2) to left and cover (3) to right.

Fig 1: Identifying Cover Retaining Screws

G03306637

Courtesy of BMW OF NORTH AMERICA, INC.

Snap out cover (1) and lift out.

Remove insert mat (2) and release screw underneath.

Fig 2: Removing Insert Mat

G03306638

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Catches (1) on cover (2) must not be damaged.

Fig 3: Identifying Catches On Cover

G03306639

Courtesy of BMW OF NORTH AMERICA, INC.

Carefully snap out handbrake gaiter (1) with special tool 00 9 317.

Remove insert mat (2) and release screw underneath.

Fig 4: Locating Handbrake Gaiter

G03306640

Courtesy of BMW OF NORTH AMERICA, INC.

Snap storage compartment (1) up and out of clips (2).

Raise storage compartment (1) and if necessary disconnect plug connections.

Remove storage compartment (1) towards top front.

Installation:

Make sure that no cables are trapped when installing the storage compartment (1).

If necessary, replace clips (2).

Fig 5: Locating Storage Compartment Clips

G03306641

Courtesy of BMW OF NORTH AMERICA, INC.