LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2010 >> Cooper S, 2D Hatchback, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Engine Controls - Removal, Overhaul & Installation - 1 Of 2) >> Ignition System >> Camshaft Position Sensor (Cylinder Identification Sensor) >> Removal & Installation (4-Cylinder)

Removal & Installation (4-Cylinder)

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 1999 BMW Z3, 1999 BMW M3, 1999 BMW M Roadster, 1999 BMW M Coupe, and 1999 BMW 740iL. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect both connectors on electrical lead duct. Cylinder identifying sensor and Digital Motor Electronics (DME) pulse sensor are located side by side on front left side of engine, identifying sensor being on top.
  2. Remove screw securing sensor lead above radiator hoses. Remove sensor lead from clip holder. Remove sensor. To install, reverse removal procedure.
scientia non olet · About LEMON Manuals