Removal & Installation (V8)

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 1999 BMW Z3, 1999 BMW M3, 1999 BMW M Roadster, 1999 BMW M Coupe, and 1999 BMW 740iL. However, it is still accessible from the selected car via links, so may be relevant.

Remove engine cover. See Figure. Disconnect idle speed control valve electrical connector. Remove top of air cleaner. Remove idle speed control valve mounting strap. Pull actuator from throttle body. To install, reverse removal procedure.

Fig 1: Removing Idle Speed Control Valve (4-Cylinder)

Courtesy of BMW OF NORTH AMERICA, INC.

Fig 2: Removing Idle Speed Control Valve (6-Cylinder)

Courtesy of BMW OF NORTH AMERICA, INC.