LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2010 >> Cooper S, 2D Hatchback, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Engine Controls - Removal, Overhaul & Installation - 1 Of 2) >> Fuel System >> Fuel Rail & Injectors >> Removal & Installation (6-Cylinder - E36)

Removal & Installation (6-Cylinder - E36)

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 1999 BMW Z3, 1999 BMW M3, 1999 BMW M Roadster, 1999 BMW M Coupe, and 1999 BMW 740iL. However, it is still accessible from the selected car via links, so may be relevant.
  1. On 3-series, it may be necessary to remove PCM cover from right side of firewall. See ENGINE CONTROL UNIT (PCM) . Unclip plastic clips along top edge of engine compartment firewall. Remove screws and wiring harness duct along engine compartment firewall. See Figure.
  2. On all models, remove engine cover. See Figure. Loosen hose clamp and disconnect fuel supply hose from fuel rail. Remove 2 bolts and pull connector plate off fuel injectors. See Figure. Remove 4 bolts and disconnect fuel rail. Pull up on fuel rail and injectors.
  3. Remove retainer from top of fuel injector. See Figure. Remove fuel injector(s). To install, reverse removal procedure. Coat injector "O" rings with petroleum jelly.
scientia non olet · About LEMON Manuals